Synth Forum

Notifications
Clear all

Yamaha PSS-E30 Remie / F30 keybed velocity sensitive?

3 Posts
3 Users
0 Likes
840 Views
Posts: 0
New Member
Topic starter
 

I understand that E30/F30 do NOT offer velocity sensitivity. My question is about the internals.

I'm looking to build a MIDI Melodica controller. I love the feel of Yamaha PSS/Reface keys and would like to use the keybed in my project.

I read the following article by Paul Drongowski and it seems to imply E30 Remie uses the same exact keybed as other keyboards in the RSS/Reface series. I was unable to find any way to reach Paul directly so I'll leave my question here.

http://sandsoftwaresound.net/inside-yamaha-pss-e30-remie/

Is it confirmed that it's a keybed with two switches per key, that just aren't supported in software?

 
Posted : 29/08/2021 4:10 pm
Jason
Posts: 7896
Illustrious Member
 

Doesn't Paul already cover this here:

The PSS series, the Reface series and the SHS-500 share the same 37-key keybed. The key switch matrices are similar. They all break the key range into groups of six keys. Each keybed is a 6 group by 6 key matrix with a dedicated group to scan the fourth C key. The PSS and Reface/SHS differ in the number of key contacts as the Reface/SHS are velocity sensitive and the PSS is not. The Reface/SHS have two contacts per key and the PSS has one contact per key. The Reface/SHS have a total of twelve sense lines (2 lines per key) while the PSS has only six sense lines.

Although "PSS series" is mentioned - I believe the velocity sensitivity comments only apply to the E30. One of the advantages listed for the A50 is addition of velocity sensitivity ("touch response" ). It's $40 more MSRP.

 
Posted : 29/08/2021 10:34 pm
 Paul
Posts: 0
Active Member
 

Hi --

Sorry, I don't get back this way very often ... 😉

Did some checking, and yes, you need to be careful here. There are hardware model differences: E30 and F30 are not velocity sensitive. A50 is velocity sensitive.

Now the nerdy stuff.

There are two different keybed printed circuit boards (PCB). Yamaha part number VAY27800 for F30/E30 and VAY28500 for A50. The A50 PCB has the necessary diodes installed for velocity sense. The F30/E30 PCB does not have the diodes. Further, the A50 board has a 12-pin connector while the F30/E30 board has an 11-pin connector -- perhaps to avoid assembly mistakes.

Is velocity sense worth the extra bucks? There may be other differences, too, but these differences are plainly visible.

And the usual caution/disclaimer -- kiss the warranty good-bye! For the money, the PSS should be good mod-fodder. Korg probably sold a mess o'monotron that way. 😀

All the best -- pj

 
Posted : 06/09/2021 4:22 pm
Share:

© 2024 Yamaha Corporation of America and Yamaha Corporation. All rights reserved.    Terms of Use | Privacy Policy | Contact Us