Notifications
Clear all
Topic starter
I downloaded the Bruno Zucchetti sounds for my CP4. I would like to add some of the sounds from that soundset to my soundset that I use for playing gigs but i don't see any way of saving or loading individual sounds-only full sets. Does anyone know of a way to do this other than writing down all the parameters and manually programming them into the other bank.
Thanks
John
Posted : 25/06/2020 5:08 pm
If you want to write anything down, write down the Names of the Performances you wish to Load from the Bruno Zucchetti data. You can select individual Performances from any CP4 STAGE ALL-data file (.C7A) by setting the Load Type properly. If you select All it loads all the data overwriting your internal, but if you set the Load Type = Performance, you can select any single Performance from that file and load just that program.
Press the [FILE] button.
On the File menu, use the [down] and [up] buttons to select 02: Load, and then press the [ENTER] button.
Use the [-1/NO] and [+1/YES] buttons or the Data Dial to select the Bruno Zucchetti file and set LOAD TYPE = Performance, and then press the [ENTER] button.
You will be able to see the individual Performance Names from within the .C7A file
Select the one you want and direct it to one of your internal locations.
Rinse and Repeat.
See your Reference Manual on how to LOAD data to the CP4 STAGE.
Posted : 25/06/2020 5:50 pm
Topic starter
Thanks Bad Mister!
Posted : 25/06/2020 10:35 pm
