Synth Forum

Notifications
Clear all

Reface Midi MINI DIN pin out?

7 Posts
4 Users
0 Likes
4,039 Views
 Bob
Posts: 0
Active Member
Topic starter
 

Does anyone know the pin config on the 6 pin mini din connector? I want to make a custom cable to my patch bank device. Any help is a appreciated.

Best,

Bob

 
Posted : 04/04/2017 2:09 am
Martin
Posts: 0
Eminent Member
 

Good question. A pin description of the Reface mini-midi cable would be good.
Yamaha should put such a description in the appendix of the Reface manuals.

or post it here in this forum 😀

 
Posted : 06/04/2017 12:03 pm
Bad Mister
Posts: 0
 

You should contact Yamaha Service - they will be able to best tell you about the breakout cable. It is not outlined in any of the User documentation.

 
Posted : 07/04/2017 1:32 pm
 Bob
Posts: 0
Active Member
Topic starter
 

Okay, any specific email address or place I should contact them? Thanks for your help!

 
Posted : 08/04/2017 4:15 pm
Bad Mister
Posts: 0
 

The one closest to you. Yamaha addresses and phone contacts are list in the Owner's Manual by country.

 
Posted : 08/04/2017 8:36 pm
Posts: 0
New Member
 

Please see Reface MIDI pin-out

I used this information to successfully create a "crossover" cable to connect two reface's with one cable (this cable send the MIDI OUT of each Reface to the MIDI IN of the other).

Orient the cable so that you are looking at the 6 pins (mini-DIN male end), with the little arrowhead at 12 o'clock. This is the orientation in which you can plug the cable into the reface. Starting at 12 o'clock (where there is no pin) and going clockwise, the pins are numbers as follows: 6, 4, 2, 1, 3, 5.

Pins 6, 4, and 2 (the 3 on on your right) are MIDI OUT
Pins 1, 3, and 5 (the 3 on your left) are MIDI IN

The specific connections are as follows:

Pin 1: MIDI IN, Ground via decoupling capacitor
Pin 2: MIDI OUT, Ground
Pin 3: MIDI IN, LED cathode (-)
Pin 4: MIDI OUT, TX serial data
Pin 5: MIDI IN, LED anode (+)
Pin 6: MIDI OUT, pull-up to 3.3V

To make my crossover cable, I bought a kenable 6-pin audio video cable, cut it in half, and reconnected the wires so that the pins on one end were connected to the pins on the other end as follows:

Pin 6 to Pin 5
Pin 4 to Pin 3
Pin 2 to Pin 1
Pin 1 to Pin 2
Pin 3 to Pin 4
Pin 5 to Pin 6

This replaces 4 cables (the 2 breakout cables, and the 2 standard MIDI cables that connect them to each other).

Good luck!

 
Posted : 25/01/2018 11:27 pm
 Bob
Posts: 0
Active Member
Topic starter
 

Thank you very much, Peter! That was some tough info to track down. I got sidetracked with my Reface Patch Bank project, but will definitely circle back to this. Thanks again!

 
Posted : 14/02/2018 9:25 pm
Share:

© 2024 Yamaha Corporation of America and Yamaha Corporation. All rights reserved.    Terms of Use | Privacy Policy | Contact Us