Can anyone point me to the correct settings for connecting to a DAW using the MODX88 Sounds, and two using the MODX88 as a controller?
When playing a Multi Part Performance on the MODX, it sends a separate MIDI stream for each active Part. This allows the synth to send MIDI information for both the Parts you are triggering directly, and send MIDI information for the Parts under control of one of the MODX’s eight Arpeggiators.
Typically, a synth sends one stream of MIDI data because all the Parts you are playing together, whether layered or split, are stacked on a single MIDI channel. That works if you have no arpeggiated Parts. As soon as you add, for example, a Drum Kit, the reason becomes very clear. If the drums are stacked on the same channel with all the Parts you are controlling, a drum note will appear under each key, and you could not keep its stream separate.
The MONTAGE/MODX, transmit on as many channels as you are actively controlling. That is perhaps a new concept... rather than stacking sounds on a single channel, you transmit out on multiple channels.
Most DAW MIDI Tracks default to recording all incoming MIDI channels... they then rechannelize the data on the way back Out. This can be chaos if you don’t setup properly.
What this means for your DAW is you can record the multiple streams of MIDI data in the following ways:
__ Setup a single MIDI Track set to receive and echo back incoming data on the channel it arrives on. This way they each can remain discreet
__ Setup a separate MIDI Track for each active Part you are controlling and restrict / filter the incoming data so that only one MIDI Channel is received by each Track and echoed back by each Track.
Because the MODX can transmit on multiple Parts and it does so in order that you can capture and playback every nuance of your performing on the instrument. The multiple streams are intended to be played back and trigger and control the MODX.
When you want to use the MODX as a MIDI controller, that is, the data you are sending is to trigger and control some other device (not a MODX), you should activate the Zone Master Function. [UTILITY] > “Settings” > “Advanced” > Set “Zone Master” = On.

This adds two screens of functions for each Part slot... allowing you to control exactly what goes Out via MIDI from each Performance.
This lets you setup a separate Part slot to address devices connected Out via MIDI. In other words, you will be creating an additional MIDI Transmit stream that instead of triggering and controlling an Internal Part, will be routed Out via MIDI.
You can customize the Part slot specially for the external device you are controlling... you can set Note Limits, Velocity Limits, Octave Transpose, Send Bank and Program messages, Volume, Pan, etc. The Zone feature allows you to intelligently setup an additional stream of MIDI data for the external device.
Please see the following article — written for the MONTAGE but applies to the MODX:
MIDI I/O and Zone Master FAQ