YamahaSynth.com Forums

This is the place to talk about all things related to Yamaha Synthesizers!
  1. ya
  2. MOXF Series Music Production Synthesizers
  3. Tuesday, 16 January 2018
Hi

When trying to sync with MOXF vst using reaper i get the message:
"ports have not been properly set"

Attached the error message and the setup i use
any ideas?

thanks
Yaniv
Attachments (2)
Responses (1)
Bad Mister
Yamaha
Accepted Answer Pending Moderation
Is Reaper VST3 compatible?

This is necessary to use the VST Editor within the DAW. Your Program is reporting that you have not selected the ports properly.

Port 1 should be selected where it indicates Port 1
Port 4 should be selected where it indicates Port 4

Port 1 is used for direct control over the hardware synthesizer, the MOXF.
Port 4 is used exclusively to control the Editor, the MOXF6/MOXF8 EDITOR VST.

Sorry, I’m not familiar with Reaper, is it supposed to support “VST3” Protocol. If yes, you can run it inside of your DAW. If not, you can run it as a stand-alone application alongside your DAW.

Contact the makers of Reaper, you need to be able to have Ports 1 and 4 active.
PORT 1 for MIDI Track Data.
PORT 4 for communication with the Editor.

You need to be able to change that Port 1 “Not Assigned” for MIDI OUT to MOXF Port 1
You need to be able to select “MOXF6/MOXF8 Port 4” for both MIDI IN and OUT where it is asking for Port 4.
  • Page :
  • 1


There are no replies made for this post yet.
Be one of the first to reply to this post!
2021 © Yamaha Corporation of America and Yamaha Corporation. All rights reserved.