YamahaSynth.com Forums

This is the place to talk about all things related to Yamaha Synthesizers!
  1. Iván
  2. MX
  3. Monday, 08 July 2019
Hi there! I've just purchased an used MX49 v1 (2012), everything works just fine except all the effects: reverb, chorus, tremolo, amp sim, wah, etc. Every patch that has at least one of those effects activated, it doesn't sound at all until I turn that effect OFF. And when I navigate through all the effects, sometimes it sounds a noisy CLICK sound between them. Can it be repaired?
Responses (1)
Accepted Answer Pending Moderation
So I did a little research and I discovered how to make it run on "TEST" mode (pressing C#1, F1 and G#1 before powering on). I did the test on: ROM, RAM, WAVE ROM, Tone Generator, etc. everything was OK, except the EFFECT RAM and EFFECT RAM 2 which gave me "NG" (opposite of OK). So I suppose that my Effects RAM failed :'(
  1. 5 days ago
  2. MX
  3. # 1
  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.
2018 © Yamaha Corporation of America and Yamaha Corporation. All rights reserved.